Where is offset on wheels

Want to see some options that will fit your vehicle? Browse wheels suited for your make and model. Important Notice: The information provided above is of a general nature gathered from a variety of resources deemed reasonably reliable.

Please consult your owner's manual for specific warnings, notices, and other advice relative to the subjects addressed herein. What is Wheel Offset? Most wheels have their correct offset data embossed on the mounting surface or on a spoke. Check out the diagrams below for a visual illustration of each offset type. Many factory rims have this offset type. This means that the offset may not be changed by more than Wheel Track reduction is NOT permitted without the approval of the relevant registration authority.

Off-road and commercial vehicles fitted with front and rear beam axles may increase the Wheel Track up to 50mm in total. All wheels fitted to the front or rear axles must have the same diameter, offset, width and mounting configuration except the spare. As an example: if you were running 10 inch mm wide tyres on the rear, your front tyres can only go as narrow as 7 inches PCD stands for Pitch Circle Diameter which basically means the diameter of an imaginary circle running through the centre of each bolt hole.

The most common PCD values are mm and Put a wheel on the front and back axles — remember that front and rear offsets can be different — and tighten the lug nuts by hand. You will also want to ensure that there is plenty of clearance for the tire when it goes on.

If offset must be substantially different, avoid using more positive offset at all costs. The offset on the new wheels may need to be less to counteract the extra width. Sean Phillips repaired, sold and installed wheels and tires for more than 10 years as the former operations manager at Rim and Wheel Works in Waltham, Mass.

Performance tire sales: From 50 years ago to 25 years ago to now. Mounting and balancing equipment and tips. Raw Material Prices Continue to Increase. No Comments. Order Reprints. The perils of bad offset If you get the offset or backspacing wrong when you are procuring and installing new wheels for a customer, you run the very real risk of having the wheel sit too far inside the wheel well, causing the inner edge of the wheel and tire to rub against the suspension.

Conclusion In summary, here are a few important points to remember about wheel offset.